MikroTik Config
Generate RouterOS configuration for your EEWIFI router.
Router Configuration
Configure your MikroTik ports before generating the RouterOS commands.
1. Router Information
2. Port 1 — Internet/WAN
ether1
Connect this port to the ISP/internet source. DHCP client is used by default.
3. Port 2 — PC + Internet
ether2
Management PC and normal internet access.
4. Port 3 — Access Point + Management
ether3
Access Point management and internet access.
5. Ports 4–10 Service Selection
Select how each port should operate.
ether4
ether5
ether6
ether7
ether8
ether9
ether10
6. Customer IP Capacity
/16 provides approximately 65,534 usable IPv4 addresses.
Important:
A private /16 network gives 65,000+ customer addresses,
but these are NOT public IPv4 addresses. Real public IPv4
addresses must be assigned by your ISP/RIR.